10
3
Connect the right-angle power cord.
1)
Check the voltage rating on your
printer (located under the top cover). The power supply will be either 110
to 127 Vac or 220 to 240 Vac, 50/60 Hz. (This is the second time you are
checking the voltage.)
2)
Make sure the power switch is in the off (“0”)
position.
3)
Connect the right-angle power cord between the printer and a grounded
power strip or ac outlet.
Note:
If the optional duplexer has been installed,
pull the duplexer out to connect the power cord, and then push the
duplexer back in.
CAUTION:
To prevent damage to the printer, use only
the power cord that is provided.
QRVWX%& HI,JKLM @NOPQ.ELRS
T
<U
U
B
<
V
<U
=
W
<
XYZ[L\
<=
=
B
<
V
<=
]
B
<
XYZ[L
<^
A
B
_
`
B
<a
b
c
@THILME'& qKLRÔÕjÕ @`BgEN<
(& )hLRêëë-,L\Z[LRÜ@8
¬,º&»d̺&»FêëLRé
9/EF8d)¾o,LR<
To Next Page
Loading...