500-sheet feeder lifter-drive assembly
1 Remove the 500-sheet feeder right-side cover. See 500-sheet feeder right-side cover.
2 Unplug the lifter-drive harness connector from the assembly PCA (location J803; callout 1).
Disconnect the tension spring (callout 2) and remove one screw (callout 3).
2
3
1
Figure 6-105 500-sheet feeder lifter-drive assembly (1 of 2)
3 Pull the tray lifter-drive assembly out towards the right side of the chassis until its pivot shaft
clears the tray guide. Rotate the lifter-drive assembly up and out of the chassis to remove it.
Figure 6-106 500-sheet feeder lifter-drive assembly (2 of 2)
282 6 Removing and replacing parts
To Next Page
Loading...