8 Remove five screws (callout 10). Pull the paper-pickup gear assembly away from the chassis
and remove it.
10
Figure 6-113 500-sheet feeder paper-pickup drive assembly (7 of 7)
NOTE When you install the tray drive gears and shaft, verify that the gears are seated
on the shaft locking bars and that the shaft collars are positioned correctly in the lower-
gear assembly mounting bracket and 500-sheet feeder chassis.
Locking bar
Shaft collar
Inner tray-drive
gear
Shaft collar
E-clip retainer
Figure 6-114 500-sheet feeder paper-pickup drive gear
Accessories 287
To Next Page
Loading...