1,500-sheet feeder media-size sensor
1 Remove the following assemblies:
● Door. See
1,500-sheet feeder door.
● Rear and right-side covers. See
1,500-sheet feeder rear cover and 1,500-sheet feeder right-
side cover.
2 Unplug the sensor wire-harness at the sensor (callout 1).
3 Remove one screw (callout 2).
4 Remove the sensor.
CAUTION Two plastic locator pins are on the back of the sensor. Be careful not to break
them when you remove the sensor.
2
1
Figure 6-127 1,500-sheet feeder media-size sensor
Reinstallation tip When you reinstall the sensor, verify that the sensor body is flush
with the chassis.
296 6 Removing and replacing parts
To Next Page
Loading...