Output-bin-full sensor
1 Remove the following assemblies:
● Reversing-separation-guide assembly. See
Reversing-separation-guide assembly
● Reversing assembly. See
Reversing assembly.
● Output bin. See
Output-bin assembly.
2 Unsnap the output-bin-full sensor from the retaining clips. Unsnap the clips at the rear of the
MFP first, and work toward the front.
Figure 6-166 Remove the output-bin-full sensor
NOTE When installing the sensor, make sure that the flag (front end) is in front of the
output-bin-detection lever. If the flag is not in front of the lever, this sensor will not function
correctly.
3 Carefully remove the spring from the from the formatter-end of the output-bin-full sensor.
CAUTION This spring can easily become dislodged from the chassis. Do not lose this
spring when you remove this assembly.
252 6 Removal and replacement
To Next Page
Loading...