HP LaserJet 6P

Removing the Tray 1 Pickup Assembly
1.
Remove Tray 1 by opening the tray at a 45° angle and pulling
up on the tray (Figure 21).
2.
Unplug the two cables (Callout
2
in Figure 22) by grasping the
cables where they attach to the plug and pulling straight back.
3.
Route the cables through the right side of the printer chassis
and bring them to the front.
4.
Remove the 5 screws (callout
1
in Figure 22) from the front of
the pickup assembly. (Two screws are adjacent in the lower left
corner.)
Figure 21 Removing Tray 1.
HP LaserJet 5P/5MP, 6P/6MP Printer Service Supplement
Removal and Replacement
49