Removing the Formatter Board and Shield
1.
Remove any installed SIMMs.
Note
There are two TORX screws holding the I/O
connector in position (Callout
1
in Figure 24).
These are the only two TORX screws in the HP
LaserJet 5P printer. Note also the location of the
test print button hole (Callout
2
) on the side of
the formatter board cover.
Figure 24 TORX Screw Locations.
HP LaserJet 5P/5MP, 6P/6MP Printer Service Supplement
Removal and Replacement
52
To Next Page
Loading...