Installation for Microsoft Windows Me
Up to two events might occur when you install the HP Color LaserJet 1600 printing-system software
using Microsoft Windows Plug and Play . If the USB Printing Support (USB001 port) does not already
exist on the computer, the installer first installs the USB Printing Support driver (steps 5 through 9). Then
the installer installs the HP Color LaserJet 1600 printer driver. The procedures described in steps 4
through 8 might not occur if USB Printing Support already exists on the computer.
In addition to the USB print support and print driver, the installer also installs the HP Toolbox. Because
the HP Toolbox is installed with the printer driver, a separate Plug and Play event does not occur.
Follow these steps to install the HP Color LaserJet 1600 printing-system software on a computer running
Microsoft Windows Me.
1. Verify that the HP Color LaserJet 1600 is turned on and that the READY message appears on the
printer control panel.
2. Quit all open programs.
3. Insert the HP Color LaserJet 1600 printing-system CD into the CD-ROM drive on your computer.
NOTE If an error message appears that says SETUP is not available in Windows 98
and ME. Please use Add Printer Wizard or Plug and Play to install the driver., click
OK and go to step 4.
4. Connect a USB cable between the printer and your computer.
5. When the New Hardware Wizard HP Color LaserJet 1600 dialog box appears, click Automatic
search for a better driver. (Recommended), and then click Next.
Figure 3-12 Add New Hardware Wizard USB Printing Support - Search for driver dialog box
ENWW Installation options 33
Software installation for
Microsoft Windows
To Next Page
Loading...
