a. In the DHCP tree, open the folder for your scope and select Reservations.
b. Click the Action menu and select New Reservation.
c. Enter the appropriate information in each field, including the reserved IP address for
your printer.
NOTE
The MAC address for your printer is available on the printer's network configuration page.
d. Under Supported types, select DHCP only, then click Add.
NOTE
Selecting Both or BOOTP only will result in a configuration through BOOTP due to the
sequence in which the printer initiates configuration protocol requests.
e. Specify another reserved client, or click Close. The reserved clients added will be
displayed in the Reservations folder for this scope.
12. Close the DHCP manager utility.
NetWare systems
NetWare 5.x servers provide DHCP configuration services for network clients, including your
HP printer. To set up DHCP services on a NetWare server, refer to Novell documentation
and support.
ENWW Using DHCP 35
To Next Page
Loading...
