Type a port name in the Port Name field and click Next to open the Installation Type dialog box (see
Figure 5-20 Installation Type dialog box).
Click Next to proceed with the installation. The Installation Type dialog box opens (see
Figure 5-20
Installation Type dialog box).
NOTE If you selected Yes on the Confirm Changing Setting dialog box (see Figure 5-14
Confirm Changing Setting dialog box), the Change TCP/IP Settings dialog box opens, as shown
in the following figure.
Figure 5-19 Change TCP/IP Settings dialog box
If you make a change in the IP Address:, Subnet Mask:, or Gateway: fields (without clicking Next)
and then click Suggest Settings…, the fields refresh with information that was found by the installer
and reported in the Printer Found screen.
Type a different TCP/IP Address, Subnet Mask, or Gateway address and then click Next to open the
Confirm Network Settings dialog box (see
Figure 5-13 Confirm Network Settings dialog box).
If you clear the Use Default Port Name check box and click Next, the Set Port Name dialog box opens
(see
Figure 5-18 Set Port Name dialog box).
ENWW Installation instructions 175
Installation in Windows
To Next Page
Loading...