●
Prepunched
●
Bond
●
Recycled
●
Color
●
Rough
NOTE To make the Print on Both Sides (Manually) check box available in the document
options, select the Allow Manual Duplexing option on the Device Settings tab in the Properties
print-driver tabs. See
Installable Options in the Device Settings tab features section of this
chapter.
If you want to print on both sides manually while using media that is supported for automatic
duplexing, you must select and apply the Not Installed setting on the Duplex Unit (for 2-Sided
Printing) option on the Device Settings tab.
Cardstock media can be manually printed on the second side, but no change occurs to the print mode.
Transparencies and labels should not be manually printed on the second side.
To print a multiple-page document, follow these steps:
1. Select the Print on Both Sides (Manually) check box.
2. Click OK. The even-number pages of the document print.
3. When the control panel shows the MANUALLY FEED message, insert the stack of media (on which
the even-number pages have been printed) as indicated in the following figure.
Figure 4-16 Print on Both Sides Instructions dialog box
When you have completed the steps that appear in the dialog box, the second half of the print job prints
on the back side of the stack of media. The driver does not require the program to specifically support
odd- and even-page printing, because the driver coordinates this function.
ENWW Finishing tab features 235
HP unidrivers for
Windows
To Next Page
Loading...