Releasing a job-storage print job
After you send a print job that uses the job-storage feature, you can release the job to print from the
product control panel.
1. Press
(the select button; the one with the check mark) to open the menus.
2. Press
(the up button) and (the down button) until RETRIEVE JOB is highlighted on the product
control panel, and then press
.
3. Press
and to scroll to your user name, and then press .
4. Press
and to scroll to the job name, and then press .
5. Press
and until PRINT is highlighted on the product control panel, and then press .
6. Press
.
7. If a PIN number is assigned to the job, press
and to select the first digit of the PIN, and then
press
. The number in the product control-panel display changes to an asterisk. Repeat this
step for each of the remaining three digits of the PIN number.
If no PIN number is assigned to the job, continue with the next step.
8. Press
and to select the number of copies to print.
9. Press
to print the job.
Deleting a job-storage print job
Sometimes it is necessary to delete a print job from the product hard disk. You can do this from the
product control panel.
1. Press
(the select button; the one with the check mark) to open the menus.
2. Press
(the up button) and (the down button) until RETRIEVE JOB is highlighted on the product
control panel, and then press
.
3. Press
and to scroll to your user name, and then press .
4. Press
and to scroll to the job name, and then press .
5. Press and until DELETE is highlighted on the product control panel, and then press .
6. Press .
7. If a PIN number is assigned to the job, press
and to select the first digit of the PIN, and then
press
. The number in the product control-panel display changes to an asterisk. Repeat this
step for each of the remaining three digits of the PIN number.
If no PIN number is assigned to the job, continue with the next step.
8. Press
to delete the job.
ENWW Job Storage tab features 247
HP unidrivers for
Windows
To Next Page
Loading...