●
Stapling: The optional stapler/stacker or booklet maker output accessory must be attached in order
to staple print or copy jobs. The staple location can be one left, one angled staple located in upper
left corner; or two left, two staples located on left long edge. For more information about stapling,
see
Use the stapler on page 126
●
The arrow in the paper graphic indicates the direction the paper will feed into the printer. The paper
graphic indicates the direction the paper should be placed in the paper tray. The default is to load
the paper so that the long edge feeds first. This results in the most efficient printing and copying.
Table 7-6 Load letterhead, pre-printed, or pre-punched paper — Image Rotation = Left to right
Paper type and
tray
Image orientation Duplex mode Staple location
options
How to load for
long-edge feed
How to load for
short-edge feed
Letterhead or Pre-
printed – Tray 1
Portrait 1- sided One left, two left
Letterhead or Pre-
printed – Tray 1
Portrait 2-sided One left, two left
HP Laserjet
HP Laserjet
Letterhead or Pre-
printed – Tray 1
Landscape 1-sided One left, two left
Letterhead or Pre-
printed – Tray 1
Landscape 2-sided One left, two left
HP Laserjet
HP Laserjet
Letterhead or Pre-
printed – Trays 2-5
Portrait 1-sided One left, two left
HP Laserjet
HP Laserjet
110 Chapter 7 Paper and print media ENWW
To Next Page
Loading...
