Resend Upgrade .................................................................................... 554
Restore Factory Settings .......................................................................... 554
ROM disk device failed To clear touch "OK# ............................................. 554
ROM disk file operation failed To clear touch "OK# ................................... 555
ROM disk file system is full To clear touch "OK# ......................................... 555
ROM disk is write protected To clear touch "OK# ....................................... 555
ROM disk not initialized To clear touch "OK# ............................................ 555
Rotating Motor ....................................................................................... 555
Scanner Failure ...................................................................................... 556
Size Mis-Match ...................................................................................... 558
Size mismatch in Tray <X> ...................................................................... 558
Sleep mode on ...................................................................................... 558
Staple Cartridge low .............................................................................. 559
Staple Cartridge very low ....................................................................... 559
Stapler/Stacker staple jam ...................................................................... 559
Supplies low .......................................................................................... 559
SUPPLY MEMORY WARNING ................................................................. 559
The unit has corrupt data ......................................................................... 560
Tray <X> empty: [Type], [Size] ................................................................ 560
Tray <X> lifting ...................................................................................... 561
Tray <X> open ....................................................................................... 561
Tray <X> overfilled ................................................................................. 562
Type mismatch Tray ................................................................................ 562
Unsupported drive installed To continue, touch "OK# .................................. 563
Unsupported supply in use OR Unsupported supply installed To continue,
touch "OK# ........................................................................................... 563
Unsupported tray configuration ................................................................ 563
Unsupported USB accessory detected Remove USB accessory ...................... 564
Upgrade Error ....................................................................................... 564
USB accessory not functional ................................................................... 564
USB hubs are not fully supported Some operations may not work properly .... 564
USB is write protected To clear touch "OK# ............................................... 564
USB needs too much power ..................................................................... 565
USB needs too much power Remove USB and Then Turn Off then On ........... 565
USB not initialized .................................................................................. 565
USB storage accessory removed Clearing any associated data .................... 565
USB storage device failure To clear touch "OK# ......................................... 565
USB storage file operation failed To clear touch "OK# ................................ 566
USB storage file system is full To clear touch "OK# ..................................... 566
Used supply installed To continue, touch "OK# OR Used supply in use .......... 566
Waiting for tray <X> to lift ...................................................................... 566
ENWW xxiii
To Next Page
Loading...