Table 2-47 Causes and solutions for pickup delay and pickup stationary jams (continued)
Cause Solution
The Tray 3 feed sensor lever is set incorrectly
or damaged.
Check the sensor lever to make sure it is set correctly. If it is damaged, replace
the paper-feeder assembly.
The spring of the Tray 3 feed sensor lever is
unhooked.
Check the spring and place it in correct position.
Poor contact of the Tray 3 feed sensor
connector.
Reconnect the connector (J405) on the paper feeder driver PCA intermediate
connector (J13) and connector (J20) of the Tray 3 feed sensor.
The Tray 3 feed sensor is defective. Run a sensor test to verify that the Tray 3 feed sensor is functioning properly. If
it is not, replace the paper-feeder assembly.
ENWW
Clear jams
357
To Next Page
Loading...