Resend Upgrade .................................................................................... 554
Restore Factory Settings .......................................................................... 554
ROM disk device failed To clear touch “OK” ............................................. 554
ROM disk file operation failed To clear touch “OK” ................................... 555
ROM disk file system is full To clear touch “OK” ......................................... 555
ROM disk is write protected To clear touch “OK” ....................................... 555
ROM disk not initialized To clear touch “OK” ............................................ 555
Rotating Motor ....................................................................................... 555
Scanner Failure ...................................................................................... 556
Size Mis-Match ...................................................................................... 558
Size mismatch in Tray <X> ...................................................................... 558
Sleep mode on ...................................................................................... 558
Staple Cartridge low .............................................................................. 559
Staple Cartridge very low ....................................................................... 559
Stapler/Stacker staple jam ...................................................................... 559
Supplies low .......................................................................................... 559
SUPPLY MEMORY WARNING ................................................................. 559
The unit has corrupt data ......................................................................... 560
Tray <X> empty: [Type], [Size] ................................................................ 560
Tray <X> lifting ...................................................................................... 561
Tray <X> open ....................................................................................... 561
Tray <X> overfilled ................................................................................. 562
Type mismatch Tray ................................................................................ 562
Unsupported drive installed To continue, touch “OK” .................................. 563
Unsupported supply in use OR Unsupported supply installed To continue,
touch “OK” ........................................................................................... 563
Unsupported tray configuration ................................................................ 563
Unsupported USB accessory detected Remove USB accessory ...................... 564
Upgrade Error ....................................................................................... 564
USB accessory not functional ................................................................... 564
USB hubs are not fully supported Some operations may not work properly .... 564
USB is write protected To clear touch “OK” ............................................... 564
USB needs too much power ..................................................................... 565
USB needs too much power Remove USB and Then Turn Off then On ........... 565
USB not initialized .................................................................................. 565
USB storage accessory removed Clearing any associated data .................... 565
USB storage device failure To clear touch “OK” ......................................... 565
USB storage file operation failed To clear touch “OK” ................................ 566
USB storage file system is full To clear touch “OK” ..................................... 566
Used supply installed To continue, touch “OK” OR Used supply in use .......... 566
Waiting for tray <X> to lift ...................................................................... 566
ENWW xxiii
To Next Page
Loading...
