Figure 2-11 Telnet error message
a. The printer network cable is not correctly connected BIOS LAN settings are incorrect.
●
The printer should be congured to use a static IP address, but is congured to use
DHCP instead.
●
The printer is congured to use a static IP address, but the IP address is incorrect.
b. The printer is correctly congured to use DHCP, but the DHCP server is not turned on or is
malfunctioning.
7. When the printer telnet server function is initialized, the following screen appears. Use the information
on this screen to connect the remote telnet client computer to the printer.
NOTE: The printer is now ready to receive remote telnet client commands.
●
IP: The static or dynamically allocated IP address for the printer.
●
Port: The standard telnet port (23).
●
Pin: A randomly generated 4-digit personal identication number (PIN).
Figure 2-12 Telnet server function initialized
Start the telnet client function at the remote computer
The following steps establish a Remote Admin connection from a remote computer to the printer.
1. From the Start menu click Run to open a dialog box, type cmd in the Open eld, and then click the OK
button to open a Windows command window.
102 Chapter 2 Solve problems ENWW
To Next Page
Loading...