Figure 2-13 Open a command window
2. From any displayed directory, type telnet at the prompt, and then press the Enter key.
Figure 2-14 Start a telnet session
3. Type o <IP ADDRESS> at the telnet prompt, and then press the Enter key.
NOTE: For <IP ADDRESS>, substitute the IP address that was displayed in step 7 in Start the telnet
server function at the printer on page 100.
TIP: If the telnet connection fails to establish a connection, the printer is probably behind a rewall or
on a dierent network that the remote telnet client computer. See Network connection on page 100.
Figure 2-15 Establish a telnet connection
ENWW Solve problems checklist 103
To Next Page
Loading...