Table 2-47 Calibration/Cleaning menu (M577) (continued)
First level Second level Values Description
Cleaning Interval Select from a list of cleaning
intervals.
Use to set the interval when the
cleaning page should be printed.
The interval is measured by the
number of pages printed.
Cleaning Size Select from a list of support sizes. Select the paper size to use for the
cleaning page.
Cleaning Page Print Use to process the cleaning page
that was created by using the
Create Cleaning Page menu. The
process takes up to 1.5 minutes.
Quick Calibration Start The product automatically
calibrates itself at various times.
However, you can calibrate the
product immediately if you see
problems with print quality. Use
this feature to perform a partial
calibration. Use this calibration if
color density or tone seems
incorrect.
Before calibrating the product,
make sure that the Ready indicator
displays on the control-panel
display. If a job is in progress, the
calibration occurs when that job is
complete.
Full Calibration Start The product automatically
calibrates itself at various times.
However, you can calibrate the
product immediately if you see
problems with print quality. Use
this feature to perform a full
calibration, which can take up to
three minutes. Use this calibration
if the color layers seem to be
shifted on the page.
Before calibrating the product,
make sure that the Ready indicator
displays on the control-panel
display. If a job is in progress, the
calibration occurs when that job is
complete.
Restore Calibration Restore If there are problems with print
quality that have not been
resolved using a Full Calibration,
touch Restore to restore the
calibration values to factory
default settings. The product will
turn o, then on.
ENWW Tools for troubleshooting 261
To Next Page
Loading...