The data in the backup le specied in the restore job ticket is no longer valid due to a corruption of the data
or no loner present.
32.1C.0D (event code)
Backup/restore failed, auto-reboot failed, or the product might be busy.
32.1C.11 (event code)
Backup/restore timeout while communicating with the engine.
The backup was aborted because the product is busy.
32.1C.13 (event code) and 32.1C.14 (event code)
Not enough space exists to perform the backup.
The backup was aborted because the disk is at a critical level or full.
Scheduled backup failure.
32.1C.15 (event code)
Restore aborted because the backup le was created by a previous version of rmware no longer supported
by the feature.
32.1C.2E (event code)
The restore was aborted because the product is busy.
32.1C.2F (event code)
Reset failure.
32.1C.40 (event code)
The backup operation completed successfully (informational).
32.1C.41 (event code)
The backup operation encountered an error (informational).
32.1C.42 (event code)
The backup operation completed, but with a warning message (informational).
32.1C.43 (event code)
A component in the backup le is not supported by the current version of rmware and will not be restored
(informational).
32.1C.44 (event code)
A component in the backup le is not transferable to another product and will not be restored (informational).
32.1C.45 (event code)
Some data was not included in the backup le (informational).
32.1C.46 (event code)
310 Chapter 2 Solve problems ENWW