HP LaserJet Enterprise M552 - Page 365

Recommended action
1. Turn the printer o, and then on.
2. If the error returns, turn the printer o and ensure the printer is directly plugged into a wall outlet
(remove any surge protector or UPS).
3. If the error persists, try a dierent wall outlet (if possible), one that is preferably on a dedicated or
dierent circuit.
4. Make sure that the correct fuser model is installed in the printer and that it meets the appropriate
voltage requirements.
5. Make sure the fuser is seated properly.
6. If the error persists, continue troubleshooting based on the individual error listed below.
Fuser Modes
0 = Photo Media 1, 2, 3
1 = Normal—Auto Sense
2 = Normal
3 = Light 1
4 = Heavy 1
5 = Heavy 2
6 = Heavy 3
7 = Glossy 1
8 = Glossy 2
9 = Glossy 3
A = Glossy Film
B = Transparency
C = Label
D = Envelope 1
E = Rough
Printer State / Sleep States
0 = Printing
1 = Standby level 1 (no temperature control)
2 = Standby level 2 (high temperature control)
3 = Standby level 3 (middle temperature control)
4 = Standby level 2 (low temperature control)
ENWW Tools for troubleshooting 337