Table 2-6 Pre-boot menu options (6 of 7) (continued)
Menu option First level Second level Third level Description
Long Use the Long item to select an extended
rmware self-test.
NOTE: This test requires about sixty
minutes to execute.
Optimized Use the Optimized item to select a test that
checks the active sectors on the disk.
NOTE: This test requires about thirty
minutes to execute.
Raw Use the Raw item to select a test that
checks every sector on the disk.
NOTE: This test requires about fty
minutes to execute.
Smart Use the Smart item to select a very brief
test that checks the drive self-monitoring
analysis and reporting technology (SMART)
status—the drive detects and reports
reliability indicators to help anticipate disk
failures (SMART status).
CPB Use the CPB item to verify the integrity of
the copy processor board (CPB) and the
formatter PCA connections.
Interconnect Use the Interconnect item to verify the
integrity of the interconnect PCA (ICB) and
its connections.
Run Selected Select the Run Selected item to execute a
selected test.
NOTE: If more than one test is selected,
they are executed in sequence.
Table 2-7 Pre-boot menu options (7 of 7)
Menu option First level Second level Third level Description
Administrator
(continued)
Remote Admin Start Telnet The Remote Admin item allows a service technician to
access to the printer Pre-boot menu remotely, and to
navigate the menu selections from a remote location.
IMPORTANT: A Remote Admin connection must be
initiated by a person that is physically present at the
printer.
This person will also need to provide a randomly
generated PIN to the remote service technician.
NOTE: For more information about using the Remote
Admin function, see Remote Admin on page 97.
Stop Telnet
Refresh IP
ENWW Solve problems checklist 95
To Next Page
Loading...