Remote Admin
The Remote Admin feature allows remote access the printer Pre-boot menu (BIOS environment). The printer
functions as a telnet server which uses the telnet networking protocol to transmit text data. Any computer
(with telnet installed and enabled) can function as the telnet client to remotely display and interact with the
Pre-boot menu.
IMPORTANT: While the Remote Admin function allows remote access the Pre-boot menu, for security
reasons the Remote Admin connection must be initiated by a person that is physically present at the printer.
This section describes the following Remote Admin items.
●
Required software and network connection
●
Connect a remote connection
●
Disconnect a remote connection
Required software and network connection
Before using the Remote Admin feature, make sure that the telnet network protocol is installed, and enabled,
on the remote telnet client computer.
NOTE: This section describes enabling and conguring the telnet feature for computers using a Windows®
operating system.
HP recommends that the telnet client computer be a Windows based system, however, there are other
operating systems that support the telnet network protocol. For information about enabling and conguring
the telnet network protocol for other operating systems, see the owner's manual for that operating system.
ENWW Solve problems checklist 97
To Next Page
Loading...