4. Type the PIN that was displayed in step 7 in Start the telnet server function at the printer on page 99 at
the prompt, and then press the Enter key.
IMPORTANT: Make sure to type the PIN correctly. After ve incorrect PIN entries, the printer terminates
the Remote Admin connection. The Remote Admin feature must be re-initiated at the printer. See Start
the telnet server function at the printer on page 99.
Figure 2-16 Enter the PIN
5. The following screen displays when the correct PIN is entered and the Remote Admin connection is
successful. For information about the Pre-boot menu and options, see Pre-boot menu options
on page 87.
NOTE: Because a Remote Admin connection is an unsecure telnet network protocol connection, the
following Pre-boot menu items are disabled for the remote telnet client computer.
●
The +3:Administrator menu 4:Change Password item.
●
The +3:Administrator menu 5:Clear Password item.
●
The +3:Administrator menu 6:Disk Manage item.
Figure 2-17 Remote Admin window
Disconnect a remote connection
The Remote Admin connection can be terminated from the printer control panel or the remote telnet client
computer.
NOTE: The following procedure describes terminating a Remote Admin connection from the remote telnet
client computer.
ENWW Solve problems checklist 103
To Next Page
Loading...