120 mm trailing edge blue duplex side
Figure 2-113 120 mm trailing edge blue duplex side
Description of the defect
A dark and usually sharp band occurring 120 mm from the trailing leading edge of a duplex page. This
impulse band is a developer blur caused by the trailing edge of the media exiting the re-feed roller nip.
Conditions that can cause the defect
This defect occurs in ll areas. This does not occur in text regions.
Solutions for the defect
●
Resend the job.
●
If the defect is persistent, try printing in Quiet Mode (1/2 speed) which, because of the slower process
speed, allows the media to enter the transfer nip more reliably and with less impact force.
At the printer control panel open the following menus: Settings > General > Quiet Mode > On.
Parts related to the defect
NOTE: The following item(s) might need to be repaired or replaced to prevent this defect form occurring.
●
Media
●
Paper path
272 Chapter 2 Solve problems ENWW
To Next Page
Loading...