2. At the back of the product, disconnect the finishing accessory interface cable.
3. Open the finishing accessory front cover. Release and hold the bottom handle first, and then release
and hold the top handle. Hold both handles at the same time, and then slide the finishing accessory
away from the product.
CAUTION: Failure to follow these instructions might damage the product.
4. Completely remove the finishing accessory.
Step two: Unpack the optional or replacement booklet maker accessory
Unpack the booklet maker from the packaging.
NOTE: Remove all tape and packing material from outside the accessory. Open all doors and remove all
tape and packing material from inside the product.
48 Chapter 2 Install and configure the finishing accessories ENWW
To Next Page
Loading...