Reinsert duplexer ........................................................................... 483
Remove one toner cartridge ........................................................... 483
Remove USB accessory ................................................................. 483
Replace <Supply> .......................................................................... 483
Replace supplies ............................................................................ 484
Resend external accessory firmware ............................................. 484
Resend Upgrade ............................................................................ 485
Restore Factory Settings ................................................................ 485
ROM disk device failed To clear touch “OK” .................................. 485
ROM disk file operation failed To clear touch “OK” ........................ 485
ROM disk file system is full To clear touch “OK” ............................ 485
ROM disk is write protected To clear touch “OK” ........................... 485
ROM disk not initialized To clear touch “OK” .................................. 486
Rotating Motor ................................................................................ 486
Size mismatch in Tray <X> ............................................................. 486
Sleep mode on ............................................................................... 486
Staple Cartridge 2 and 3 very low (warning) .................................. 486
Staple Cartridge <X> low (warning) ................................................ 487
Staple Cartridge low ....................................................................... 487
Stapler/Stacker staple jam .............................................................. 487
Supplies low ................................................................................... 487
Supply Memory Warning ................................................................ 487
The unit has corrupt data ................................................................ 487
Too many pages in job to staple ..................................................... 488
Too many pages to make booklet .................................................. 488
Tray <X> [type] [size] ...................................................................... 488
Tray <X> empty: [Type], [Size] ....................................................... 488
Tray <X> lifting ............................................................................... 489
Tray <X> open ................................................................................ 489
Tray <X> overfilled ......................................................................... 490
Type mismatch Tray <X> ............................................................... 490
Unsupported drive installed To continue, touch “OK” ..................... 490
Unsupported supply in use OR Unsupported supply installed To
continue, touch “OK” ....................................................................... 491
Unsupported tray configuration ...................................................... 491
Unsupported USB accessory detected Remove USB accessory ... 491
Upgrade Error ................................................................................. 491
Upper left bin full ............................................................................. 491
USB accessory not functional ......................................................... 492
USB hubs are not fully supported Some operations may not work
properly ........................................................................................... 492
xx ENWW
To Next Page
Loading...
