Booklet maker and booklet maker with hole punch
The booklet maker is optionally installed at the side of the product. The booklet maker with hole
puncher assembly has the hole punching function in addition to the standard stapler/stacker function.
The booklet maker delivers the printed paper as follows:
●
To the output bin.
●
To the output bin, after stapling.
●
To the saddle output bin, after saddle-stitching and double-folding.
NOTE: The saddle function (saddle-stitching or saddle output bin delivery) does not apply to hole-
punched paper.
The stacker controller and the saddle stitcher controller control the operational sequence of the
booklet maker. The stacker controller, saddle stitcher controller, and hole punch controller control the
operational sequence of the booklet maker with the hole puncher assembly.
Figure 1-114 Booklet maker installation and paper path
Output bin
Saddle assembly
Staple stacker assembly
Inlet feed assembly
Saddle output bin
156 Chapter 1 Theory of operation ENWW
To Next Page
Loading...