●
The guide plate covers the folding rollers to prevent interference between paper and the paper
folding rollers when paper is output. The guide plate moves down to expose the paper-folding
rollers before the paper is folded.
●
The inlet has three paper sensors (PI18, PI19, PI20) that are each suited to specific paper sizes.
●
The paper-positioning plate has a paper-positioning-plate paper sensor (PI8).
Figure 1-127 Components of the booklet-maker-unit control system
SL1
SL4
SL2
M8
M6/
M7
M1
M5
M3
PI1
M2
M4
PI4
Feed motor drive signal
Guide motor drive signal
Stitcher motor drive signal
(front/rear)
Paper pushing motor drive signal
Alignment motor drive signal
Paper pushing motor clock signal LUNGECLK
No.1 paper deflecting plate
solenoid drive signal FLPSL1
No.2 paper deflecting plate
solenoid drive signal FLPSL2
Feed plate contact solenoid drive signal RLNIPSL
Paper folding motor clock signal FLDCLK
Paper folding motor drive signal
Paper positioning plate motor
drive signal
Saddle stitcher controller PCA (2/2)
Saddle inlet
solenoid drive
signal
SDLINSL
M9
SL5
Saddle inlet
motor drive
signal
Saddle stitcher controller PCA (1/2)
Stacker controller
PCA
172 Chapter 1 Theory of operation ENWW
To Next Page
Loading...