Table 2-79 Service menu (continued)
First level Second level Value Description
Cycle Counts Total Engine Cycles Set the page count that
was stored in NVRAM
prior to installing a new
formatter.
Refurbish Cycle Count Use this item to record
the page count when
the product was
refurbished.
Document Feeder Kit Count (M880 only) Total number of pages
since the document
feeder kit was
replaced.
Document Feeder Kit Interval (M880 only) Use this item to set the
interval that causes the
product to prompt the
customer to replace
document feeder
maintenance kit.
Clean Rollers Count (M880 only) Total number of pages
since the document
feeder rollers were
cleaned.
Clean Rollers Interval (M880 only) Use this item to set the
interval that causes the
product to prompt the
customer to clean the
document feeder rollers
and separation pad.
ADF Count (M880 only) Set the total pages fed
through the document
feeder.
Flatbed Count (M880 only) Set the total pages
scanned from the
flatbed.
ADF Simplex Count (M880 only) Set the total single-
sided pages fed
through the document
feeder.
ADF Duplex Count (M880 only) Set the total two-sided
pages fed through the
document feeder.
Copy Scan Count (M880 only) Set the total copy
pages that have been
scanned.
Send Scan Count (M880 only) Set the number of
scanned pages sent to
email.
Fax Scan Count (M880 only) Set the number of
scanned pages that
have been faxed.
Copy Pages Count (M880 only) Set the number of
scanned pages that
have been printed.
Duplex Feed Cycle Count Reset the number of
duplex pages that have
been printed.
ENWW Service mode functions 733
To Next Page
Loading...