Table 2-79 Service menu (continued)
First level Second level Value Description
Scanner Settings
NOTE: M880 product only.
ADF Settings Leading-edge
Trailing-edge
Left Side
Front
Left Side
Back
Set the calibration
values.
WARNING! Do not
change these values
unless instructed to do
so.
Glass Settings Leading edge
glass
Left Side
Glass
Set the calibration
values.
WARNING! Do not
change these values
unless instructed to do
so.
Serial Number Set the serial number.
Service ID Use this item to show
the date that the
product was first used
on the control panel.
This eliminates the
need for users to keep
paper receipts for proof
of warranty.
Cold Reset Paper When you perform a
cold reset, the paper
size that is stored in
NVRAM is reset to the
default factory setting.
If you replace a
formatter board in a
country/region that
uses A4 as the
standard paper size,
use this menu to reset
the default paper size
to A4. LETTER and A4
are the only available
values.
New Duplex Roller Set this item to Yes if
the duplexing feed
assembly is replaced.
Media Sensor Value Use this item to record
the media sensor value
found on a replacement
paper pickup assembly.
734 Chapter 2 Solve problems ENWW
To Next Page
Loading...