HP LaserJet Enterprise MFP M725 - Page 30

Declaration of conformity
Declaration of Conformity
according to ISO/IEC 17050-1 and EN 17050-1
Manufacturer's Name: Hewlett-Packard Company DoC#: BOISB-1105-01-Rel.3.0
Manufacturer's Address: 11311 Chinden Boulevard
Boise, Idaho 83714-1021, USA
declares, that the product
Product Name: HP LaserJet Enterprise MFP M725dn
Regulatory Model Numbers:
2)
BOISB-1105-01
Product Options: All
Toner Cartridges: CF214A, CF214X
conforms to the following Product Specifications:
SAFETY: IEC 60950-1:2005 +A1:2009/ EN60950-1: 2006 +A11:2009 +A1:2010 +A12:2011
IEC 60825-1:2007 / EN 60825-1:2007 (Class 1 Laser/LED Product)
IEC 62479:2010 / EN 62479:2010
GB4943.1-2001
EMC:
CISPR22:2008/ EN55022:2010 - Class A
1), 3)
EN 61000-3-2:2006 +A1:2009 +A2:2009
EN 61000-3-3:2008
EN 55024:1998 +A1:2001 +A2:2003
FCC Title 47 CFR, Part 15 Class A
1)
/ ICES-003, Issue 4
GB9254-2008, GB17625.1-2003
RoHS: EN 50581:2012
Supplementary Information:
The product herewith complies with the requirements of the EMC Directive 2004/108/EC, the Low Voltage Directive 2006/95/EC, and
the RoHS Directive 2011/65/EC, and carries the CE-Marking
accordingly.
This Device complies with Part 15 of the FCC Rules. Operation is subject to the following two Conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
1. The product was tested in a typical configuration with Hewlett-Packard Personal Computer Systems.
2. For regulatory purposes, these products are assigned a Regulatory model number. This number should not be confused with the product
name or the product number(s).
3. The product includes LAN (Local Area Network) options. When the interface cable is attached to LAN connectors, the product meets
the requirements of EN55022 & CNS13438 Class A in which case the following applies: “Warning – This is a class A product. In a
domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.”
24 Chapter 3 Regulatory information ENWW