Convenience-stapler power supply bracket and strap (HP LaserJet
M2727nfs only)
1. Remove the following components.
●
Right cover. See
Right cover on page 100.
●
Convenience-stapler power supply (HP LaserJet M2727nfs only). See
Convenience-stapler
power supply (HP LaserJet M2727nfs only) on page 124.
NOTE: When you remove the convenience-stapler power supply, you also remove the
sheet-metal strap.
2. Remove three screws (callout 1), and then separate the sheet-metal bracket (callout 2) from the
product chassis to remove it.
Figure 5-48 Remove the convenience-stapler bracket and strap
1
2
ENWW Internal assemblies 127
To Next Page
Loading...