HP LaserJet M2727 MFP Series - Page 159

Fan
1. Remove the following components.
●
Right cover. See
Right cover on page 100.
●
Left cover. See
Left cover on page 102.
●
Rear cover. See
Rear cover on page 106.
●
Scanner/ADF assembly. See
Scanner/ADF assembly on page 117.
●
Top cover. See
Top cover on page 108.
●
Convenience-stapler power supply. See
Convenience-stapler power supply (HP LaserJet
M2727nfs only) on page 124.
●
Convenience-stapler power supply bracket. See
Convenience-stapler power supply bracket
and strap (HP LaserJet M2727nfs only) on page 127.
●
Power-switch PCA and mounting bracket. See
Power-switch PCA on page 130
2. Disconnect one connector (callout 1; J209) at the ECU and feed the wire harness through the hole
in the chassis (behind the power-switch PCA).
Figure 5-64 Remove the fan (1 of 2)
1
ENWW Internal assemblies 141