2. Remove three screws (callout 1), and then lift the assembly away from the product.
NOTE: The gears are not attached to the gear plate. Carefully remove the gear plate and the
gears together to prevent them from falling out of the assembly. If the gears are separated from
the assembly, see
Figure 5-67 Replace the duplex-drive gears on page 144 to correctly reinstall
them.
Figure 5-66 Remove the duplex-drive gears
1
TIP: It might be easier to replace the assembly if you place the two large gear sets into the
appropriate holes on the chassis first, and then line up the holes in the gear plate with the gears
as you replace the plate.
Figure 5-67 Replace the duplex-drive gears
144 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...