3. Disconnect the connectors along the edge of the ECU (callout 2). Remove the wire harness from
the guides (callout 3).
Figure 5-71 Remove the fuser (2 of 9)
2
3
4. Remove one screw (callout 4) from the wire harness guide and separate it from the product.
Reinstallation tip You might find it easier to reassemble the wire harnesses and the wire harness
holder if you put the smaller wires in place first.
Figure 5-72 Remove the fuser (3 of 9)
4
148 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...