After completing service
●
Reinstall the print cartridge.
CAUTION Do not transport the MFP while the print cartridge is installed.
●
Reconnect all cables to the MFP.
●
Replace all of the accessories and load the media.
●
Print a Configuration page and verify that the latest firmware is installed on the MFP.
Screws that are used in the MFP
The following table describes the screws that are used in the MFP and provides guidelines to help
determine where each type of screw is used. The screws can vary in length depending on the
thickness of the material that is being fastened. Always note where each type of screw is located and
replace each one in its original location.
NOTE When you are disassembling the MFP, place the screws into the chassis holes from
which they were removed. This prevents their loss and ensures that the correct type and
length of screw for each location is used when the MFP is reassembled.
222 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...