4. Squeeze the locking tab that is in the center of the left side of the hard drive. Push up on the
hard drive to remove it.
Figure 5-34 Remove the hard drive (2 of 2)
DIMM
WARNING! The MFP contains components that are sensitive to electrostatic discharge
(ESD). Always perform service work at an ESD-protected workstation. If an ESD-protected
workstation is not available, discharge body static by grasping the MFP chassis before
touching an ESD-sensitive component. Ground the MFP chassis before servicing the MFP.
NOTE If possible, print a menu map and a Configuration page. Use the information on the
these pages to restore any user-set MFP configuration options after you install the
replacement DIMM.
1. Remove the formatter cover, and open the formatter cage door.
ENWW User-replaceable parts 243
manuals4you.commanuals4you.com
To Next Page
Loading...