2. Disconnect the paper-size-detection-switch connector (callout 1). Remove one screw (callout 2).
Push in on the paper-size-detection switch, and then slide the switch toward the right side of the
MFP and remove it.
Figure 5-161 Remove the paper-size-detection switch (1 of 2)
Tray 2 paper-present sensor (PS101)
1. Use a short #2 Phillips screwdriver to remove the screw.
Figure 5-162 Remove the tray 2 paper-present sensor
2. Remove the tray 2 paper-present sensor.
314 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...