Specks
Specks might appear on a page after a jam has been cleared.
1. Print a few more pages to see if the problem corrects itself.
2. Clean the inside of the device and run a cleaning page. See
Clean the device.
3. Try using a different type of media.
4. Check the print cartridge for leaks. If the print cartridge is leaking, replace it.
Dropouts
1. Make sure that the environmental specifications for the device are being met. See Operating
environment.
2. If the media is rough, and the toner easily rubs off, open the Administration menu at the device
control panel. Open the Print Quality menu, select Fuser Modes, and then select the media type
you are using. See
Print Quality menu.
3. Try using a smoother media.
ENWW Solve print-quality problems 211
To Next Page
Loading...