2. Use a small flat blade screwdriver to carefully remove three locking clips (callout 1).
CAUTION: Do not damage the PCA with the screwdriver.
Figure 1-276 Remove the high-voltage power supply lower (2 of 4)
1
3. Disconnect one connector (callout 1; J114), and then release five clips (callout 2).
NOTE: To locate DC controller connector locations, see DC controller PCA on page 8.
Figure 1-277 Remove the high-voltage power supply lower (3 of 4)
2
1
190 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...