High-voltage power supply upper
Before proceeding, remove the following components:
●
Toner-collection unit. See
Toner-collection unit on page 15.
●
Formatter PCA. See
Formatter PCA on page 17.
●
Right-rear cover. See
Right-rear cover on page 90.
●
Left cover. See
Left cover on page 92.
●
Rear-upper cover. See
Rear-upper cover on page 95.
●
Rear cover. See
Rear cover on page 98.
●
Interconnect board (ICB). See
Interconnect board (ICB) on page 148.
●
DC controller. See
DC controller PCA and tray on page 150.
●
Low-voltage power supply (LVPS). See
Low-voltage power supply (LVPS) on page 153.
Remove the high-voltage power supply upper
CAUTION: ESD-sensitive part.
1. Remove one screw (callout 1).
Figure 1-325 Remove the high-voltage power supply upper (1 of 5)
1
ENWW
Removal and replacement procedures
221
To Next Page
Loading...