2. Remove four screws (callout 1), and then rotate the sheet-metal plate away from the power supply.
NOTE: You do not need to completely remove the sheet-metal plate to access the power supply.
Figure 1-326 Remove the high-voltage power supply upper (2 of 5)
1
3. Disconnect two connectors (callout 1; J201, J202) from the back side of the power supply.
NOTE: For clarity, the figure in this step shows the document feeder and scanner removed.
Carefully reach under these components to access the two connectors.
Figure 1-327 Remove the high-voltage power supply upper (3 of 5)
1
222 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...