5. Verify that the cams (callout 1) align correctly.
TIP: The second cam in from the right (the white cam to the left of the black cam), should have
the
second
hole aligned with the hole in the sheet-metal chassis.
The third cam in from the right, should have the
third
hole aligned with the hole in the sheet-metal
chassis.
The fourth cam in from the right (the cam nearest the developing-disengagement motor), should
have the
fourth
hole aligned with the hole in the sheet-metal chassis.
If the second, third, or fourth cams do not correctly align, do the following. Hold the long drive
shaft, gently tilt the cam and gear away from the shaft to allow clearance to rotate the gear until
the correct hole in the gear aligns with the hole in the chassis.
Figure 1-345 Reinstall the main-drive assembly (5 of 11)
1
ENWW
Removal and replacement procedures
235
To Next Page
Loading...