HP LASERJET M575 - Assembly Locations Overview

●
High-voltage power supply upper. See
High-voltage power supply upper on page 221.
●
Main-drive assembly. See
Main-drive assembly on page 228.
Remove the fuser-drive assembly
1. Disconnect one connector (callout 1), and then release the wire harnesses from the guide
(callout 2).
Figure 1-352 Remove the fuser-drive assembly (1 of 6)
2
1
2. Remove two screws (callout 1), and then remove the guide (callout 2).
Figure 1-353 Remove the fuser-drive assembly (2 of 6)
1
2
240 Chapter 1 Removal and replacement ENWW