Foam reflector kit
1. Open the document feeder.
2. Carefully peel the foam reflector from the document feeder.
Figure 1-45 Remove the foam reflector kit (1 of 2)
Reinstall the foam reflector
▲
Place the foam reflector on the scanner glass with the adhesive facing up. Make sure the corner of
the foam reflector is aligned with the corner of the scanner glass (callout 1). Close the document
feeder (callout 2) to attach the foam reflector. Open the document feeder and then press firmly on
the foam reflector to ensure it is securely attached.
Figure 1-46 Reinstall the foam reflector
1
2
38 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...