2. Carefully raise the front of the product.
WARNING! Do not place the product face-up resting on the rear cover and rear door. Excess
toner might enter the laser/scanner assembly and contaminate the mirrors, causing print-quality
problems. The laser/scanner is not a FRU. If the laser/scanner mirrors are contaminated, the entire
product must be replaced.
CAUTION: Do not lift the product by grasping the front door and Tray 2 cavity.
NOTE: The roller is located inside the tray cavity.
Figure 1-5 Remove the pickup roller (1 of 2)
3. Release the two white plastic locking tabs and remove the pickup roller.
Figure 1-6 Remove the pickup roller (2 of 2)
ENWW
Removal and replacement procedures
11
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com
To Next Page
Loading...