Rear-upper cover (duplex product)
1. Open the rear cover.
2. Remove two screws (callout 1).
Figure 1-25 Remove the rear-upper cover (1 of 2)
1
3. Slightly separate the cover from the product, and rotate the cover down and then away from the
product to remove it.
Figure 1-26 Remove the rear-upper cover (2 of 2)
24 Chapter 1 Removal and replacement ENWW
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com
To Next Page
Loading...