4. Close the duplex assembly, lift up on one side of the cover, and then lift up the other side of the
cover to release it.
Figure 1-46 Remove the rear-lower cover and link-guides (duplex product) (4 of 6)
5. Slightly lift up the rear-door rib assembly, and then carefully slide the cover away from the product
to remove it.
Figure 1-47 Remove the rear-lower cover and link-guides (duplex product) (5 of 6)
36 Chapter 1 Removal and replacement ENWW
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com
To Next Page
Loading...