4. Disconnect two connectors (callout 1), release the fan wire harness from the guide (callout 2), and
then remove three screws (callout 3).
Figure 1-75 Remove the right panel (4 of 8)
1
23
5. Place the power button in the on position (callout 1).
TIP: When you reinstall the panel, ensure that you place the power button in the off position so
that the product does not immediately turn on when the power cord is plugged into the wall
receptacle.
Figure 1-76 Remove the right panel (5 of 8)
1
54 Chapter 1 Removal and replacement ENWW
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com
To Next Page
Loading...